Ericsson 7700 Manual Do Utilizador

1. Press r 

Menu

.

2. Press d until 

MAINTENANCE 

is highlighted, then press r.

3. Press d until you see 

CLOCK SETTING

, then press r

.

4. Use the d, u, and r

 

buttons to set each item in the date and time, 

displayed in the following format: 

MM/DD/YY HH:MM

.

5. Press 

OK

 to save the setting.

Maintenance mode allows you to make special settings and perform 
maintenance procedures that may be needed occasionally. You can use 
maintenance mode to do the following:

•

Change the language or units of measurements used on the printer’s 
control panel menus.

•

Adjust the maximum value for roll paper tension.

•

Run a “super strong” cleaning cycle.

•

Return all of the printer’s control panel settings to their default values.

Follow these steps to use maintenance mode:

1. Make sure the printer is turned off.

2. Press and hold the 

 

button, then press the P power button and 

hold it until the printer turns on and the LCD displays 

MAINTENANCE MODE.

3. Use the d and u buttons to select the settings described below. If you 

need to back up to the previous menu level, press l.

•

To change the language on the LCD display, press d to highlight 

LANGUAGE

, then press r. Press d until you see the language you 

want, then press 

OK

 to select it. The printer exits maintenance 

mode and returns to normal operation.

Note: You can use the 
PRINTER SETUP menu to 
enable the roll paper 
counter, paper size 
check, and several other 
printer features. For more 
information, see 
page 217.