Ericsson 7700 Manual Do Utilizador
162
162
|
Maintaining and Transporting the Printer
•
To change the units of measurement, press d
to highlight
LENGTH
UNITS
, then press r. Press d to switch from
METRIC
to
FEET/INCH
, then press
OK
to select it. Press
l
when done.
•
To change the temperature units of measurement, press d
to
highlight
TEMPERATURE UNITS
, then press r. Press d to switch
from
C
(Celsius or centigrade)
to
F
(Fahrenheit), then press
OK
to
select it. Press
l
when done.
•
To change the maximum roll paper tension, press d to highlight
ROLL PAPER TENSION
, then press
r
. Press d to decrease the
maximum value, or u
to increase it (from 1 to 5). Press
OK
to select
the setting you want.
•
To run a super strong cleaning cycle, press d to highlight
SS CLEANING
, then press r
to display
EXECUTE
. Press
OK
to
start the cleaning cycle.
•
To return all control panel settings to their default values, press d
to
highlight
DEFAULT PANEL
, then press r
to display
EXECUTE.
Press
OK
to restore the default settings.
4. To exit maintenance mode, turn off the printer by pressing the P power
button. Press the P power button again to turn on the printer in the
normal operating mode.
normal operating mode.
Replacing the Paper Cutter
If you notice that your paper isn’t being cut cleanly, the cutter may need to
be replaced.
be replaced.
You can obtain a new cutter from Epson (part number C12C815331). See
page 12 for ordering details.
page 12 for ordering details.
Removing the Old Cutter
Make sure the printer is turned on, then follow these steps to remove the
blade:
blade:
1. Press r
Menu
.
2. Press d until
MAINTENANCE
is highlighted, then press
r
.