Ricoh DSm721d Manual Do Utilizador

When You Cannot Print

43

If the printing does not start, contact your service representative.

Printing does not start.

If the machine is operating in an 
extended wireless LAN, the re-
ceiver's MAC address may be 
preventing communication with 
the access point.

Check access point settings when 
in infrastructure mode. Depending 
on the access point, client access 
may be limited by MAC address.

Also, check there are no problems in 
transmission between access point 
and wired clients, and between ac-
cess point and wireless clients.

Printing does not start.

The extended wireless LAN has 
not started.

Confirm the orange LED is lit, 
and the green LED is lit or blinks 
during transmission.

Printing does not start.

Advanced encryption has been set 
using the Extended Security function.

Check the settings of the Extended Se-
curity function with the administrator.

Printing does not start.

The login user name, password, or 
driver encryption key is invalid.

Check the login user name, password, 
or driver encryption key is correct.

The Data In indicator 
does not blink or light 
up.

If the Data In indicator is unlit or 
not flashing even after perform-
ing [Print], the machine has not re-
ceived the data.

• When the machine is connect-

ed to a computer via a cable, 
check the computer print port 
settings are correct. For how 
to check the print port, see 
“Confirming the Connection 
Method”, Printer Reference.

• When it is networked with a com-

puter, contact the administrator. 

The status indicator of 
the machine is red.

The cause is displayed on the dis-
play of the control panel.

Check the error message on the 
display panel and take required 
action. See p.39 “When a Message 
Is Displayed”.

Updating the destina-
tion list. Reselect desti-
nation(s) or sender's 
name later.

The destination list is being up-
dated from the network using 
SmartDeviceMonitor for Admin 
or Web Image Monitor.

Wait until the message disap-
pears. Do not switch off the pow-
er while this message is 
displayed. Depending on the 
number of destinations to be up-
dated, there may be some delay 
before you can resume operation. 
Operations are not possible while 
this message is displayed.

 is dis-

abled.

A mechanical error might have 
occurred. 

Contact your service representa-
tive. See “List/Test Print”, Gener-
al Settings Guide.

Printing does not start 
when using extended 
wireless LAN in Ad-
hoc mode.

Correct communication mode is 
not set.

Turn the main power off and back 
on. See “Turning On the Power”, 
About This Machine.

Or, change the settings in [Net-
work]

 under [Interface Settings] of 

. See “Network 

Settings”, General Settings Guide.