Primera Technology Optical Disc Printing System Manual Do Utilizador

•

Release both buttons

•

To stop the test, wait until the disc has moved to the

Output Bin and press the Power Button.

C. CLEANING THE INK CARTRIDGES

It may be necessary to clean the ink cartridge nozzles if you

notice reduced print quality, or if you suspect a cartridge 

nozzle has become slightly dried out or clogged. Refer to

Section 3 for more information on performing a clean function

through the Printer's printer driver.

D. CLEARING A MEDIA JAM

If a disc should become jammed inside the printing area of the

Printer, with the lid closed press the Cartridge Button. This will

eject the Printer Tray. Then open the lid. The Cartridge Carrier

will move to the center position automatically. WAIT FOR THE

CARTRIDGE CARRIER TO STOP MOVING! Then carefully

move the cartridge carrier assembly to the left to gain access to

the printer tray.

E.

TRANSPORTING THE PRINTER

To prevent damage to the Printer’s robotic arm during 

shipment, it is important to properly secure it.
To prepare for transport, remove the ink cartridges and disc

holders, close the front cover and then do the following:
1.  With the front cover closed, switch off power to the unit.
2.  Press and hold the Cartridge Button.
3.  While continuing to hold the Cartridge Button, switch on

power to the unit.

Continue to hold the Cartridge Button for five seconds.  After

several more seconds, the robotics will undock and the arm

will lower.  Power will shut off automatically once the robotics

are in transport position.  If you have the cardboard spacer that

was shipped with the unit, replace the spacer inside the unit

and close the cover.  If you don't have the cardboard spacer,

secure the arm and cartridges to the sides of the unit with tape

and close the cover.

510921PM.qxd  1/26/2005  11:12 AM  Page 37