Paxar 9840CL Manual Do Utilizador

••

Errors 700 to 765 happen when there is a problem with the printer.

700

An error is pending, and the printer cannot continue with the batch.

701

Printer received a command that it cannot execute while it is running.

702

Check your printer’s SETUP settings.

703

The printer sensed a calibration of different-sized black marks.

704

Printer didn’t detect a sense mark within the maximum feed length or out of
supplies.  Check or load supplies.

705

Invalid batch received.

750

Printhead is overheated.  Turn off the printer and let it cool.

751

Printer didn’t detect a sense mark when expected.

752

Printer detected a sense mark in the wrong place.

753

Printer detected a sense mark that is too long.

754

Out of ribbon or ribbon jam.  Check or load ribbon.  Remove any slack in the
ribbon by turning the take-up reel clockwise.  Load a new ribbon.

755

Printhead is open.  Close the printhead.

756

Out of supplies.  Load supplies.

757

Reload supplies (supply length mismatch).

758

The supply was not seen or the On-Demand sensor is not working correctly.  Check
for a supply jam.  Clear the supply path or reload supplies.  This error may occur if
you remove a label too quickly in the On-Demand mode.  The printer does not
recalibrate after this error.

759

Knife is not moving.  Call Technical Support.

760

Knife jam.  Call Technical Support.

761

Stacker is full or jammed.  Empty the stacker before continuing.

762

Low battery.  Recharge the battery.

763

Waiting to dispense label.  Press Feed.

764

Verifier failure.  Call Technical Support.

765

The printhead has less than four bad spots.  The printer can shift bar code fields to
avoid bad dots.  Press Clear to continue printing.  Print a test label to confirm the
number of bad dots.