Konica Minolta 752 Manual Do Utilizador
5-3.Removing Jam
DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6 55
"
Film jam between exposure section and
elevator transport section
elevator transport section
The screen on the right shows the example where a film jam
occurs between the elevator transport section and the
exposure section (the subscan unit). Follow the procedure
below to remove the jammed film.
occurs between the elevator transport section and the
exposure section (the subscan unit). Follow the procedure
below to remove the jammed film.
(1) Lift the film outlet cover on the front-lower part of
the device to open by lifting the green handle.
Opening the cover to an upright position fixes it with magnets.
(2) Press the green lever on the lower-right of the front
device rightward until it is locked.
(3) Turn the green handle on the lower-right of the front
device counterclockwise.
The film in the elevator transport section will return to the sub-
scan unit.
scan unit.
(4) When the film can be seen in the subscan unit, put
your hand from the film outlet.
(5) While turning the handle further, fold the edge of
the film back.
(6) When the film comes out of the subscan unit com-
pletely, remove it from the film outlet.
(7) Close the film outlet cover and then the front cover.
The normal screen will re-appear after a while when the mes-
sage of "PLEASE WAIT" appears.
When there queued print data remains, printing starts automat-
ically.
sage of "PLEASE WAIT" appears.
When there queued print data remains, printing starts automat-
ically.
Green handle
Film outlet cover
Green lever
Green edge
Film
CAUTION
The front cover cannot be closed with the film
outlet cover open. If you find it difficult to close
the front cover, check that the film outlet cover is
closed.
Do not close the front cover forcibly.
outlet cover open. If you find it difficult to close
the front cover, check that the film outlet cover is
closed.
Do not close the front cover forcibly.