Toshiba 960-809 Manual Do Utilizador

To execute this program, input  1 in the startup menu. Then press Enter to select the 

(2)-

Initial config set

. The H/W initial information setting tool consists of four subtests. 

 

Input the number you want to execute and press Enter.  

NOTE:   Connect USB FDD, when you perform the Repair test program from the CD-

ROM. DMI information on the subtest 02 is written in floppy disk. 

Subtest 01  

Initial configuration 

 

 

 

 

This subtest executes the following items and shows their contents in the 
display. When an item ends normally, the program proceeds automatically to 
the next one. When an error is found, the program stops and waits for key 
input. (After solving the problem, the program executes the item again.) 

Setting of the CPU set table 
Setting of the micro code 
Setting of the EHSS 
Inputting and writing of DMI information 

 

 

 

 

 

 

When the DMI information is displayed,  the following messages 
appear in order. Input each information. (If you do not replace the 
PCB, the DMI information should not be changed.) 

1.  “Enter Model Name?” is displayed. Input the computer’s model 

name and press Enter. (e.g. DynaBook) 

2.  “Enter Version Number?” is displayed. Input the computer’s 

version number and press Enter.  (e.g. PC18070C313S) 

3.   “Enter Serial Number?” is displayed. Input the computer’s serial 

number and press Enter. (e.g. 12345678) 

4.  “Enter Model Number?” is displayed. Input the computer’s sales 

model number and press Enter. (e.g. PP200-AAAAA) 

5.   “Enter Bundle Number?” is displayed. Input the computer’s 

PCN/Bundle number and press Enter.  
(e.g. PMSREQ3Q34H/S0123456789) 

6.  “Write data OK (Y/N)?” is displayed. To write the DMI 

information to the Flash ROM, press Y, and then Enter.