Netgear NETGEAR Manual Do Utilizador
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-84
Switching Commands
202-10088-01, March 2005
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
802.
Default
ethernet
Format
hardware-address <hardwareaddress> [type]
Mode
DHCP Pool Config
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode
DHCP Pool Config
host
This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32
Default
none
Format
host <address> [mask | prefix-length]
Mode
DHCP Pool Config
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode
DHCP Pool Config
ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP clients.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Default
none
Format
ip dhcp excluded-address <lowaddress> [highaddress]