Netgear NETGEAR Manual Do Utilizador

Routing Commands

10-5

This command displays the Address Resolution Protocol (ARP) cache. The displayed results are 
not the total ARP entries. To view the total ARP entries, the operator should view the 

results in conjunction with the 

 results.

Is the time it takes for an ARP entry to age out. This value was 

configured into the unit. Age time is measured in seconds. 

Response Time (seconds)  Is the time it takes for an ARP request timeout. This value 

was configured into the unit. Response time is measured in sec-
onds. 

Is the maximum number of times an ARP request is retried. This 
value was configured into the unit.

Is the maximum number of entries in the ARP table. This value 
was configured into the unit. 

Dynamic Renew Mode   Displays whether the ARP component automatically attempts to 

renew dynamic ARP entries when they age out. 

Total Entry Count Current / Peak  Field listing the total entries in the ARP table and the 

peak entry count in the ARP table. 

Static Entry Count Current / Max  Field listing the static entry count in the ARP table and 

maximum static entry count in the ARP table. 

Is the IP address of a device on a subnet attached to an existing 
routing interface. 

Is the hardware MAC address of that device. 

Is the routing slot/port associated with the device ARP entry. 

Is the type that was configured into the unit. The possible values 
are Local, Gateway, Dynamic and Static. 

This field displays the current age of the ARP entry since last 
refresh (in hh:mm:ss format