Netgear NETGEAR Manual Do Utilizador

10-6

Routing Commands

This command displays the brief Address Resolution Protocol (ARP) table information.

Is the time it takes for an ARP entry to age out. This value was 

configured into the unit. Age time is measured in seconds. 

Response Time (seconds)  Is the time it takes for an ARP request timeout. This value 

was configured into the unit. Response time is measured in sec-
onds. 

Is the maximum number of times an ARP request is retried. This 
value was configured into the unit.

Is the maximum number of entries in the ARP table. This value 
was configured into the unit. 

Dynamic Renew Mode   Displays whether the ARP component automatically attempts to 

renew dynamic ARP entries when they age out. 

Total Entry Count Current / Peak  Field listing the total entries in the ARP table and the 

peak entry count in the ARP table. 

Static Entry Count Current / Max  Field listing the static entry count in the ARP table and 

maximum static entry count in the ARP table. 

This chapter provides a detailed explanation of the IP Routing commands. The commands are 
divided by functionality into the following different groups:

•

Show commands are used to display switch settings, statistics and other information. 

•

Configuration Commands are used to configure features and options of the switch. For every 
configuration command there is a show command that will display the configuration setting.

•

Copy commands are used to transfer configuration and informational files to and from the 
switch. 

This command enables routing for an interface.