Netgear NETGEAR Manual Do Utilizador

Quality of Service (QoS) Commands

11-21

Expedite (all forms)

This command identifies a minimum amount of bandwidth to be reserved for the specified class 
instance within the named policy using a relative rate notation. The committed information rate is 
specified as a percentage of total link capacity and is an integer from 1 to 100.

The actual bandwidth allocation does not occur until the policy is attached to an interface in 

a particular direction.

The bandwidth kbps and percent commands are alternative ways to specify the same 

bandwidth policy attribute.

The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not 
exceed the available link bandwidth of the interface to which that 
policy is assigned. Violation of this requirement shall prevent 
successful attachment of a policy to the interface, or shall cause 
this command to fail if the policy is already in service on one or 
more interfaces.

Out

Expedite (all forms)

This command creates an instance of a class definition within the specified policy for the purpose 
of defining treatment of the traffic class through subsequent policy attribute statements. The 
<

 is the name of an existing DiffServ class. Note that this command causes the 

specified policy to create a reference to the class definition.

The CLI mode is changed to Policy-classmap Config when this command is successfully 

executed.