Netgear NETGEAR Manual Do Utilizador

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Quality of Service (QoS) Commands

11-23

202-10088-01, March 2005

Note:

The actual bandwidth allocation does not occur until the policy is attached to an interface in

a particular direction.

Note:

The expedite kbps and percent commands are alternative ways to specify the same expedite

policy attribute.

Format

expedite percent <1-100> [1-128]

Mode

Policy-classmap Config

Restrictions

The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.

Policy Type

Out

Incompatibilities

Bandwidth (all forms), Shape Peak

mark cos

This command marks all packets for the associated traffic stream with the specified class of
service value in the priority field of the 802.1p header. If the packet does not already contain this
header, one is inserted. The CoS value is an integer from 0 to 7.

Default

Format

mark-cos <0-7>

Mode

Policy-classmap Config

Policy Type

mark ip-dscp

This command marks all packets for the associated traffic stream with the specified IP DSCP
value.

The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through one of
the following keywords:

af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,

af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.

Format

mark ip-dscp <dscpval>

Mode

Policy-classmap Config