Netgear NETGEAR Manual Do Utilizador

Switching Commands

8-25

Locally Administered MAC Address  If desired, a locally administered MAC address 

can be configured for in-band connectivity. To take effect, 'MAC 
Address Type' must be set to 'Locally Administered'. Enter the 
address as twelve hexadecimal digits (6 bytes) with a colon 
between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 
0, i.e. byte 0 should have the following mask 'xxxx xx10'. The 
MAC address used by this bridge when it must be referred to in a 
unique fashion. It is recommended that this be the numerically 
smallest MAC address of all ports that belong to this bridge. 
However it is only required to be unique. When concatenated 
with dot1dStpPriority a unique BridgeIdentifier is formed which 
is used in the Spanning Tree Protocol. 

Specifies which MAC address should be used for in-band con-
nectivity. The choices are the burned in or the Locally Adminis-
tered address. The factory default is to use the burned in MAC 
address.

Network Configuration Protocol Current  Indicates which network protocol is being 

used. The options are bootp | dhcp | none. 

Specifies if the switch should allow access to the Java applet in 
the header frame. Enabled means the applet can be viewed. The 
factory default is disabled.

Specifies the management VLAN ID.  

This command displays telnet settings.

 

Remote Connection Login Timeout (minutes)  This object indicates the number of 

minutes a remote connection session is allowed to remain inac-
tive before being logged off. A zero means there will be no time-
out. May be specified as a number from 0 to 160. The factory 
default is 5. 

Maximum Number of Remote Connection Sessions  This object indicates the num-

ber of simultaneous remote connection sessions allowed. The fac-
tory default is 5.