Netgear NETGEAR Manual Do Utilizador

Switching Commands

8-27

ServPort Configuration Protocol Current  Indicates what network protocol was used on 

the last, or current power-up cycle, if any. 

Burned in MAC Address  The burned in MAC address used for in-band connectivity.

This command displays SNMP community information. Six communities are supported. You can 
add, change, or delete communities. The switch does not have to be reset for changes to take 
effect.

The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP 
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external 
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community 
parameters).

SNMP Community Name  The community string to which this entry grants access. A valid 

entry is a case-sensitive alphanumeric string of up to 16 charac-
ters. Each row of this table must contain a unique community 
name. 

An IP address (or portion thereof) from which this device will 
accept SNMP packets with the associated community. The 
requesting entity's IP address is ANDed with the Subnet Mask 
before being compared to the IP Address. Note: that if the Subnet 
Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches all IP 
addresses. The default value is 0.0.0.0 

A mask to be ANDed with the requesting entity's IP address 
before comparison with IP Address. If the result matches with IP 
Address then the address is an authenticated IP address. For 
example, if the IP Address = 9.47.128.0 and the corresponding 
Subnet Mask = 255.255.255.0 a range of incoming IP addresses 
would match, i.e. the incoming IP Address could equal 
9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0