Omega Vehicle Security CN3271 Series Manual Do Utilizador

Indicators

Indicators
“RESET“ =Indicates control output 1 status as

follows:
a) When C2 parameter has been

configured equal to 0,
LED ON when Output 1 is OFF
LED OFF when Output 1 is ON

b) When C2 parameter has been

configured equal to 1,
LED flashes when Output 1 is OFF
LED ON when Output 1 is OFF and
acknowledged
LED OFF when Output is ON

“ALM” = Indicates alarm status as follows:

- Flashes when alarm is ON
- ON when alarm has been resetted but

the alarm condition is still present.

- OFF when alarm is OFF

“REM” = Indicates the remote status of the

instrument.
- Flashes when instrument is in remote

mode.

- OFF when instrument is in local mode.

Key Functions in Normal Display Mode

Key Functions in Normal Display Mode
“FUNC” = By pressing it, the display changes from

“Normal Display Mode” to “Operative
Parameter Display Mode.”

= Pressing it for more than ten seconds

initiates the Lamp Test. During the Lamp
Test the device function normally while all
display segments and LED's are lit with a
50% duty cycle. No timeout is applied to
a lamp test.
Press the "FUNC" key again to end the
Lamp Test.

" " or “ " = By pressing these keys it is possible to

change the displayed information. See
“Normal Display Mode” on previous
page.

“RESET” = Press and hold for 1 second to rearm

(reset) the limiter.

+ FUNC or + FUNC

Increases/decreases values at a higher
rate when modifying parameters.

+ RESET or + RESET

Jumps to the Maximum or Minimum
parameter value when modifying
parameters.

Operative Parameter Display Mode

Operative Parameter Display Mode
The "FUNC" key initiates the Operative Parameter
Display Mode when pressed for less than 10
seconds in the "Normal Display Mode."

The lower display shows the parameter code while the
upper display shows the parameter value or status.
The value of the selected parameter can be modified
with the and keys.

Press the "FUNC" key again to store the new value
and advance to the next parameter.

If no keys are pressed within the timeout period
(see t1), the instrument will automatically return to
the "Normal Display Mode" in the previous display
and any modification of the last displayed
parameter will be lost.

All parameters (except a ) can be modified only
when the device is UNLOCKed.

The LOCK/UNLOCK status can be selected in
configuration using “n1” parameter or during the
operating mode with the “nn” parameter (pass-
word).

LHL-1-NEUTRO.pmd

19/04/2004, 15.07