Avocent ECMS2000U Manual Do Utilizador

Operating a computer through the Avocent Emerge

TM

 ECMS2000U Extender is no different than 

working directly connected to your computer. All peripherals operate as if directly connected, even 
though the computer is located at a distance. When you power up the User Access Node, a 
connection is automatically established with the computer. 

While the default settings of your Avocent Emerge ECMS2000U Extender will work with most 
systems, you may choose to change settings to better fit your system. Internal settings such as 
connection settings can be configured via the serial menu. See The Serial Menu on page 14. You 
can also upgrade the Avocent Emerge ECMS2000U Extender via the serial menu.

There are two blue LEDs on the front panel of the User Access Node. The PWR LED will light up 
when the User Access Node has been powered up. The ACTIVE LED will blink slowly until the 
User Access Node establishes a connection with the Computer Access Node. When a connection 
has been established between the User Access Node and the Computer Access Node, the ACTIVE 
LED will stop blinking and will remain lit.

Two LEDs are built into both the RJ-45 connector on the rear of the User Access Node, and into the 
RJ-45 connector on the Computer Access Node. The following table illustrates their operation.

LED 1

Green static

Linked at 1 Gbps

Green flashing

Linked at 100 Mbps

Green off

No Link