Avocent ECMS2000U Manual Do Utilizador

14        Avocent Emerge ECMS2000U Extender Installer/User Guide

When the User Access Node is powered up, it will automatically initiate a connection with the 
remote computer.

1.

Power up the User Access Node. 

2.

A series of messages will be displayed on the screen to inform you of the progress 

 

of the connection.

3.

You will be able to interact with the remote computer as if it were located at your desk.

NOTE: If the remote computer has been powered down, the User Access Node cannot establish a connection. 

The User Access Node incorporates a serial menu that allows you to:

•

Configure network settings for the User Access Node

•

Configure network settings for the Computer Access Node

•

Set or change passwords

•

Upgrade your firmware for the User Access Node and Computer Access Node

•

Reset to factory defaults

•

Set a session time-out value

•

Change the audio performance settings

You can access the serial menu via the serial port on the back of the User Access Node. All terminal 
commands are executed through a terminal or PC running HyperTerminal® emulation software 

 

or equivalent.

NOTE: In this section of the manual the term “Transmitter” will be used to refer to the Computer Access Node.

NOTE: In this section of the manual the term “Receiver” will be used to refer to the User Access Node.

LED 2

Yellow static

Linked but no activity

Yellow flashing

Transmit/receive activity