McDATA 8832 Manual Do Utilizador
IBM BladeCenter Deployment Guide
Version 3.0, 3/10/2006
http://w3-03.ibm.com/support/techdocs/atsmastr.nsf/WebIndex/WP100564
29
Figure 33 fdisk Output
Note: If you see this message shown in Figure 34, answer no. In this situation, it may be possible to
install successfully without the %pre script since it won’t attempt to partition the second path.
install successfully without the %pre script since it won’t attempt to partition the second path.
Figure 34 Invalid Partition Table
Aside from the 2 differences noted above, the process detailed in Section 4 is essentially unchanged; just
make sure you are using the correct diskette image.
make sure you are using the correct diskette image.
4.4 Red Hat Linux AS Broadcom driver installation
After loading the operating system, the network drivers should work immediately. However, we
downloaded the latest Broadcom device drivers for Linux and performed the instructions in Example 6-1
to install them. The latest Broadcom device drivers were obtained from the following URL:
downloaded the latest Broadcom device drivers for Linux and performed the instructions in Example 6-1
to install them. The latest Broadcom device drivers were obtained from the following URL:
[root@fafrin root]# fdisk -l
Disk /dev/sda: 18.1 GB, 18158714880 bytes
255 heads, 63 sectors/track, 2207 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 * 1 13 104422 83 Linux
/dev/sda2 14 1543 12289725 83 Linux
/dev/sda3 1544 1805 2104515 82 Linux swap
/dev/sda4 1806 2207 3229065 83 Linux
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.