Alcatel-Lucent 6850-48X Manual Do Utilizador

Connections and Cabling

11

Once your switch is properly set up and all the required hard-
ware components are installed, you should connect all network 
and management cables required for your network applica-
tions. Connections may include:

RJ-45 cable connection to the console port

Single mode or multimode fiber cables to combo port 
SFPs as required by your network

Ethernet cables to 10/100/1000 or 10/100 Ethernet 
ports as required by your network

The console port, located on the chassis front panel, provides a 
serial connection to the switch and is required when logging 
into the switch for the first time. By default, this RJ-45 
connector provides a DTE console connection.

Note. For stacked configurations, the serial cable should 
be connected to primary management module. If you are 
connecting the serial cable to a stack, it is advisable to 
wait until the stack has booted and the primary module has 
been dynamically assigned. Refer to the OmniSwitch 6850 
Series Hardware Users Guide for more information.

The default settings for the serial connection are as follows:

Note. For information on modifying these settings, refer to 
the OmniSwitch 6850 Series Hardware Users Guide.

9600

none

8

1