Alcatel-Lucent 6850-48X Manual Do Utilizador

12

Booting OmniSwitch 6850 Series Switches

The OmniSwitch 6850 Series switch does not use an on/off 
switch. The power cord is the switch’s only connect/discon-
nect device. The power connector socket is located on the 
switch’s rear panel. For more information, refer to the 
OmniSwitch 6850 Series Hardware Users Guide.

To boot the switch, plug the power cord (provided) into the 
power connector socket at the switch’s rear panel. Next, plug 
the power cord into an easily-accessible power source, such as 
a grounded AC outlet or an Uninterruptible Power Supply 
(UPS).

The switch immediately begins the boot process. Allow a few 
moments for the switch to boot completely, then verify the 
status of all LEDs on the switch’s front panel. A successful 
boot for a standalone switch displays the following LED 
states:

OK

Solid green

PRI

Solid green

PWR

Solid green

BPS

Solid amber, if BPS attached is failed; 
off, if no operational BPS is attached; 
solid green if an operational BPS is 
attached and operating normally.

XFP1

Off (applies to all OmniSwitch 6850 
Series switches except for the 
OmniSwitch 6850-24X,
OmniSwitch 6850-P24X, 
OmniSwitch 6850-48X,
OmniSwitch 6850-P48X, and 
OmniSwitch 6850-U24X). 

XFP2

Off (applies to all OmniSwitch 6850 
Series switches except for the 
OmniSwitch 6850-24X,
OmniSwitch 6850-P24X, 
OmniSwitch 6850-48X,
OmniSwitch 6850-P48X, and 
OmniSwitch 6850-U24X). 

Slot Indicator

1–8 (non-blinking), depending on the 
slot number value in the boot.slot.cfg 
file. See the OmniSwitch 6850 Series 
Hardware Users Guide for detailed 
information. The default value is 1.