Adtran ADT-1234POE Manual Do Utilizador
NetVanta 1000/1000R Series Hardware Installation Guide
Unit Installation
61200500L1-34N
Copyright © 2008 ADTRAN, Inc.
55
Wall Mounting the NetVanta
By following these instructions exactly, the NetVanta can be safely mounted to the wall.
Figure 36. Wallmount Installation
Instructions for Wall Mounting the NetVanta
Step
Action
1
Remove the mounting ears. Rotate them 90 degrees so that the portion of the bracket with the
mounting holes is flush with the bottom of the chassis. Reattach the mounting ears to the
chassis (see Figure 36).
mounting holes is flush with the bottom of the chassis. Reattach the mounting ears to the
chassis (see Figure 36).
2
Decide on a location for the NetVanta. All NetVanta 1000 and 1000R Series units are mounted
with the front panel facing down (see Figure 36). Keep in mind that the unit needs to be
mounted at or below eye-level so that the LEDs are viewable.
with the front panel facing down (see Figure 36). Keep in mind that the unit needs to be
mounted at or below eye-level so that the LEDs are viewable.
3
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud.
to a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
sufficient long-term stability.
4
Have an assistant hold the unit in position as you install two #6 to #10 (1 1/2 inches or greater
in length) wood screws through the unit’s brackets and into the mounted board (see Figure 36).
in length) wood screws through the unit’s brackets and into the mounted board (see Figure 36).
5
Proceed to the steps given in Supplying Power to the Unit on page 56.
To avoid damaging the unit, use only the screws included in the shipment when attaching
mounting ears to the chassis.
mounting ears to the chassis.
SLO
T 1 NIM/VIM
CONSOLE
100-250 V
AC
50-60Hz