Pressure Systems 9016 Manual Do Utilizador
Pressure Systems, Inc.
9016 Upgrade Instructions
www.PressureSystems.com
10
Figure 11
PC-327 Connection and Cable Tie-down
PC-322/323
connection to
the PC-327
board
connection to
the PC-327
board
Note
orientation of
red stripe
orientation of
red stripe
Figure 12
Side View of 9016 Upgrade
Figure 13
Top View of 9016 Upgrade
(5)
Carefully guide the LEDs (on the PC-322 board) into their respective holes in the scanner
chassis. Ensure that all cables and tubing are not crimped or restricted and attach the PC-
322/323 boards to the chassis with the three (3) Phillips-head screws through the top plate
(that were previously removed and saved). Do not tighten completely.
chassis. Ensure that all cables and tubing are not crimped or restricted and attach the PC-
322/323 boards to the chassis with the three (3) Phillips-head screws through the top plate
(that were previously removed and saved). Do not tighten completely.
(6)
Connect the ribbon cable from P3 on the PC-322/323 board to the connector on your PC-327
board (red line indicates pin 1). (See Figure 11.)
board (red line indicates pin 1). (See Figure 11.)
(7)
Insert a plastic cable tie-down through the tie-down mount previously installed and around
the clear plastic tubing as shown in Figure 11.
the clear plastic tubing as shown in Figure 11.
The following two pictures show a completed 9016 module upgrade with side and top views.