Pressure Systems 9016 Manual Do Utilizador
Pressure Systems, Inc.
9016 Upgrade Instructions
www.PressureSystems.com
11
Final Installation
(1)
Carefully reinstall the module into the housing, aligning the retaining pins in the housing
with holes in the brackets on your PC-322/323 boards. Ensure that none of the wiring
harnesses or nylon tubing are pinched. Ensure the Viton
with holes in the brackets on your PC-322/323 boards. Ensure that none of the wiring
harnesses or nylon tubing are pinched. Ensure the Viton
®
gasket is flat between the two
surfaces and is without folds. Tighten the three screws for this PC-323 board.
(2)
Re-install the twelve (12) Phillips-head screws around the top plate perimeter.
(3)
Install the upgrade kit tag on the end of your scanner, just below the serial
number/nameplate. The tag is designed to fit directly beneath the nameplate. Clean the
surface of the with isopropyl alcohol to achieve good adhesion. Peel off the protective
covering layer of double-faced tape and position the sticker as described above.
number/nameplate. The tag is designed to fit directly beneath the nameplate. Clean the
surface of the with isopropyl alcohol to achieve good adhesion. Peel off the protective
covering layer of double-faced tape and position the sticker as described above.
Final Checkout
Test your Intelligent Pressure Scanner for proper operation. For operation of your newly
upgraded Intelligent Pressure scanner, please refer to your 9116 User’s Manual, available
from the Pressure Systems web site,
upgraded Intelligent Pressure scanner, please refer to your 9116 User’s Manual, available
from the Pressure Systems web site,
www.PressureSystems.com.