SMART Technologies 600i4 Manual Do Utilizador

 

CHAPTER 5 – TROUBLESHOOTING YOUR INTERACTIVE WHITEBOARD 
SYSTEM

Integrated Interactive Whiteboard Ready Light Status

Your interactive whiteboard’s LED Ready light is in the lower-right corner of the frame. 
This light indicates the operational state of the controller module. If your interactive 
whiteboard behaves erratically or becomes unresponsive, or if the LED displays a 
color other than green when it’s on, try resetting the power by disconnecting the USB 
connection to your computer. 

Adding a SMART UF65 or SMART UF65w projector and an ECP changes the 
standard behavior of the interactive whiteboard Ready light. The following status light 
explanations only occur when you connect a computer source to your interactive 
whiteboard system’s VGA1 or VGA2 ports, and the USB input and the input source 
are both active.

Off

Your interactive whiteboard isn’t receiving power. Confirm that 
the projector is on. Confirm that your interactive whiteboard’s 
USB cable is connected to the ECP. On the projector’s 
input/output panel, check the ECP’s 4-pin powered-mini-DIN 
connection. If nothing changes after you check your connectors, 
call your 

Solid red

Your interactive whiteboard is receiving power but isn’t 
communicating with a computer. On the projector’s input/output 
panel, check the ECP’s 7-pin mini-DIN connections. Confirm 
that the projector input selection is set to the correct video input 
source (VGA1 for primary computer, VGA2 for secondary com-
puter). Confirm that the USB connection from the computer is 
connected to the appropriate computer connection on the ECP.

Solid green

Your interactive whiteboard is on and communicating with your 
computer.