SMART Technologies 600i4 Manual Do Utilizador

CHAPTER 5 – TROUBLESHOOTING YOUR INTERACTIVE WHITEBOARD 
SYSTEM

 

Projector Ready Lights and Projector 
Status

The SMART UF65 or SMART UF65w projector’s two indicator LED lights (Power and 
Service) are located on the boom-mounted projector. Specific light sequences convey 
information about the state of the projector, including errors.

IMPORTANT
After you resolve the projector’s issue, disconnect and then reconnect the 
projector power cable to clear the indicator light sequence, and then reset the 
projector’s status.

Flashing green

Your interactive whiteboard is on and communicating with your 
computer, but it’s in Mouse mode. Confirm that SMART Product 
Drivers is installed on your computer.

Flashing amber

Your interactive whiteboard system is turning on, is in service 
mode or has detected a firmware error. On the projector’s 
input/output panel, check the ECP’s 4-pin powered-mini-DIN 
connection. If nothing changes after you check your connectors, 
call your 

Solid amber

Off

The projector is off but still receiving power 
(Idle mode). Press the power button   on the ECP 
to turn it on.

Flashing green

Off

The projector is in the powering (startup) power 
state. Wait for the projector to finish powering on.

Solid green

Off

The projector is in the operating (on) power state. 
Press the power button on the ECP twice to turn 
it off.

Flashing amber Off

The projector is in the cooling power state. Wait for 
the projector to finish cooling.

Off

Flashing red

The projector is overheating. The projector might 
shut down automatically. See The “Projector 
Overheated” Message Appears on page 68 to 
troubleshoot the projector.