SMART Technologies 600i4 Manual Do Utilizador
82 |
CHAPTER 6 – MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM
Removing the Projector from the Boom
Before you can access the projector lamp module, you must remove the projector
from the boom.
Before you can access the projector lamp module, you must remove the projector
from the boom.
WARNING
Two people are required to remove the projector from the boom.
Two people are required to remove the projector from the boom.
To remove the projector
from the boom
1. Turn off the projector by pressing the Power
button twice on the remote
control or ECP to put the system into Idle mode.
2. Wait at least 30 minutes for the projector to completely cool down, and then
disconnect the power cable from the power outlet.
3. Remove the cable cover, and then disconnect all cables from the projector.
4. While firmly holding the projector, and without applying pressure or weight to the
projector boom, remove the screw holding the projector cover in place with a
Phillips® No. 2 screwdriver, and then remove the cover. Place the cover and
screw in a safe place.
Phillips® No. 2 screwdriver, and then remove the cover. Place the cover and
screw in a safe place.
5. If you use a projector padlock, remove it from the locking loop. If you need to
access the projector locking screw, loosen the wingnut and slide the projector
away from your interactive whiteboard’s screen, and then tighten the wingnut.
away from your interactive whiteboard’s screen, and then tighten the wingnut.