ZyXEL Access Point G1000 v2 91-005-124001B Manual Do Utilizador

ZyXEL G-1000 v2 User’s Guide

34

Chapter 2 Introducing the Web Configurator

Figure 4   Change Password Screen

6 On this screen you can access the wizard setup or the advanced setup. 

Click Go to Advanced setup to access the status screen of the web configurator

.

Note: The management session automatically times out when the time period set in 

the Administrator Inactivity Timer field expires (default five minutes). Simply log 
back into the G-1000 v2 if this happens to you.

If you forget your password or cannot access the web configurator, you will need to reload the 
factory-default configuration file or use the RESET button on the top panel of the G-1000 v2. 
Uploading this configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had 
previously and the password will be reset to 1234.

.

Make sure the SYS light is on (not blinking) before you begin this procedure. 

Press

 the RESET button for ten seconds or until the SYS light starts to blink, and then 

release it. If the SYS light begins to blink, the defaults have been restored and the G-1000 
v2 restarts. Otherwise, go to step 2.

Turn the

 G-1000 v2 off.

While

 pressing the RESET button, turn the G-1000 v2 on.

Continue 

to hold the RESET button. The SYS light will begin to blink and

 

flicker very 

quickly after about 20 seconds. This indicates that the defaults have been restored and the 
G-1000 v2 is now restarting.

Release

 the RESET

button and wait for the G-1000 v2 to finish restarting.