Ariens 921025 Manual Do Utilizador

GB - 15

3. Make sure that the traction clutch and 

attachment drive clutch levers are fully 
disengaged.

4. Open fuel shutoff valve.
5. Set the engine shut off switch to the 

"On" position to start and operate the 
engine.

6. If engine is cold,  apply choke. A warm 

engine requires less choking than a cold 
engine. See Engine Manual for detailed 
instructions. 

7. Set throttle to proper starting position
8. Press starter button on engine until 

engine starts.

IMPORTANT: DO NOT operate starter more 
than 15 seconds per minute, as overheating 
and damage can occur. (If engine does not 
start, refer to Troubleshooting on page 28.)

9. Adjust choke as needed.

10. Disconnect power cord from outlet, then 

starter.

11. Set throttle to Part Throttle or Slow 

position for adaptation to outside 
temperature or travel. Set throttle to Fast 
position for normal operation.

1. Release both clutch levers and wait for 

all moving parts to come to a complete 
stop.

2. Run unit a few minutes after use to 

prevent freeze-up.

3. Move throttle to STOP position.
4. Set the engine shut off switch to the "Off" 

position to shut off a running engine. 

After proper Pre-Start and Starting:

1. Select speed control position and 

direction.

IMPORTANT: DO NOT overload unit capacity 
by sweeping at too fast a rate.

2. Engage the traction drive clutch first.
3. Engage the attachment clutch next.

To clear an area, run unit in an overlapping 
series of paths. For large areas, start in the 
middle and sweep debris to each side, so it is 
not cleared more than once. 

ALWAYS direct discharge away from area to 
be cleared and with direction of the wind.

Snow is best removed as soon as possible 
after snow fall. 

To travel from one work area to another:

1. Set throttle to SLOW position or slightly 

higher. 

2. Press down the handlebars enough to 

raise the front of the unit slightly off the 
surface.

3. Engage traction clutch without engaging 

the attachment drive clutch.

ALWAYS shut off engine and close fuel shut-
off when transporting unit on a truck or trailer.

Use extra care when loading or unloading 
unit onto trailer or truck.

Secure unit chassis to transport vehicle. 
NEVER secure from rods or linkages that 
could be damaged.
DO NOT transport machine while engine is 
running.

IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors.

Run unit a few minutes after each use to free 
unit of any debris.

Close fuel shut-off valve.
Inspect unit for visible signs of wear, 
breakage or damage.

Keep all nuts, bolts and screws properly 
tightened and know unit is in safe working 
condition.

Store unit in a cool, dry protected area.

Clean unit thoroughly with mild soap and low 
pressure water and lubricate (see General 
Lubrication on page 18). Touch up all 
scratched painted surfaces.

Remove weight from wheels by putting 
blocks under frame or axle.

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.