Ariens 921025 Manual Do Utilizador

GB - 16

Gasoline left in the fuel system for extended 
periods without a stabilizer will deteriorate, 
resulting in gum deposits in the system. 
These deposits can damage the carburetor 
and the fuel hoses, filter and tank. Prevent 
deposits from forming in the fuel system 
during storage by adding a quality fuel 
stabilizer to the fuel. Follow the 
recommended mix ratio found on the fuel 
stabilizer container.

To treat the fuel system for storage:

1. Add fuel stabilizer (Ariens p/n 00592900) 

according to manufacturer’s instructions.

2. Run engine for at least 10 minutes after 

adding stabilizer to allow it to reach the 
carburetor.

NEVER store the engine with fuel in the fuel 
tank inside of a building with potential 
sources of ignition.

Ariens Dealers will provide any service or 
adjustments which may be required to keep 
your unit operating at peak efficiency. Should 
engine service be required, contact an Ariens 
dealer or an authorized engine 
manufacturer's service center.

 

(Figure 8, 9, and 10)

IMPORTANT: DO NOT tip unit up onto brush. 
Remove the brush if maintenance requires 
tipping the unit forward. Ensure unit is secure 
and will not tip over. Strap or clamp unit onto 
bench if required.
To access components in the unit frame:

1. Shut off engine and allow unit to cool 

completely. Place unit on a flat level 
surface.

2. Remove belt cover.
3. Remove hardware attaching remote 

trigger cable to brush assembly and 
detach cable (Figure 8).

4. Remove the six cap screws from the 

bottom cover. Remove the bottom cover 
before separating unit.

5. Remove cap screws and belt finger 

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

WARNING: ALWAYS remove key 
and/or wire from spark plug before 
assembly, maintenance or service. 
Unintentional engine start up can 
cause death or serious injury.

Figure 8

OSS0269

Detach cable here.