Genie 3022 Manual Do Utilizador

15

Basic monthly maintenance tasks include:

•  Contact Reverse Test

•  Lubricate door hardware

•  Safe-T-Beam® System check

•  Door balance

•  Remote Battery Replacement (As needed)

•  Light Bulb Replacement (As needed)

See page 8.

Inspect door rollers and hinges and lubricate as needed using a  

light weight general purpose grease.

Check that both the RED and GREEN LEDs are ON steady. This indicates 

the system is working properly. If both LEDs are not ON steady, check 

the appropriate items below:

•  STB red LED flashes. 

– Check for obstruction. 

– Check alignment. (See page 18) 

– Verify wire routing from STBs to STB connection in powerhead 

– Check for signal interference from another Safe-T-Beam® unit  

  (for multiple door installations).

•  No STB red or green LED displayed. 

– Check wiring and wire connections

If system appears to be working properly, perform check as follows:

1. Start the door closing.

2. Pass an object through the beam. The door should stop and  

reverse to the fully open position.

– Door should remain stationary or move very slowly. 

– If door moves quickly, CONTACT A TRAINED DOOR SYSTEM  

  TECHNICIAN to have your door springs serviced.

•

Close the door.

•

Place the carriage in the “engage” position (see illustration

reversed).

•

Operate door using remote or wall control. The carriage will 

 

reattach itself to the drive chain/belt.

(continued)

Replace remote battery with a CR2032 coin cell battery.

1. Slide the battery cover off (it’s the lower half of the remote’s case) by pressing on the case just below 

the indentation at the top of the cover and sliding it down. Alternately, insert a coin or small washer into 

2. Slide out the old battery and slide in the new. Be sure positive side (+) is UP.

3. Slide the battery cover on until it snaps into place.

Replace remote battery with a CR2032 coin cell battery.

1. Open remote case using a washer or coin that fits into the slot on the top of the remote.

2. Replace battery. Be sure positive side (+) is UP.

3. Align components and snap case closed.

•

Raise and lower the door

manually — it should move

 

freely and smoothly.

•

Raise door manually about

3’ to 4’ feet and let go.

Perform the check as follows:
•

With the door closed, pull manual emergency release handle to 

release the carriage from the shuttle (Screw Drive) or the bullet 

(Chain/Belt Drive).

Disengage the carriage by pulling 

the release handle straight down, 

and then releasing

Disengage the carriage by pulling 

the release handle down, toward 

the door and then releasing