Genie 3022 Manual Do Utilizador

17

Speed settings are pre-programmed at the factory for the 

maximum speed. Speed settings should not need adjustment 

with this unit. However, travel speed for the opener can 

be adjusted to a slower speed in both the Open and Close 

directions, to minimize wear on heavier sectional doors.

There are three speed settings available for sectional doors.

Please note that speed may be affected by door weight and 

balance, along with condition of door components and tracks.

Press and hold both up and 

down arrow buttons until 

round LED turns RED, release 

buttons. Round BLUE LED will 

flash 3 times.

 LEDs will now display current UP force setting (See chart).

Press either arrow button until 

desired UP force setting is 

reached.

See Chart

Once setting is chosen, press 

and release. This will lock the 

UP force setting. 

LEDs will now show current DOWN force setting. (See Chart).

Press either arrow button until 

desired DOWN force setting is 

reached. 

See Chart

Once setting is chosen, press 

and release. This will lock the 

DOWN force setting. 
The LEDs will now turn BLUE then off. This confirms 

that both force settings have been set and unit is 

ready for normal operation.
Repeat “Learn Force Limits and Contact Reverse Test” page 8

OFF

BLUE

BLUE

OFFFlashes 

3 Times

OFF

RED

BLUE

See pages 6-7-8 to reset travel limits. Force setting and contact 

reverse test must be performed in the event of a travel limit change.

NOTE: The opener will not close automatically unless the