Amana W10245579A Manual Do Utilizador

Página de 36
7
5. Turn on the water shutoff valve. Run water into a shallow pan 
to flush the water line (copper tubing or flexible braided water 
supply line) of particles that may clog the inlet valve.
6. Turn off the water shutoff valve.
Install Drain Hose
IMPORTANT: Always use a new drain hose even when installing 
a new replacement dishwasher.
Drill a 1
¹⁄₂" (3.8 cm) diameter hole in the cabinet wall on the 
side of the opening closest to the sink.
Connect Drain Hose to Air Gap—Waste Disposer
1. Remove the waste disposer knockout plug. Cut the end of the 
drain hose, if needed.
NOTE: Do not cut the ribbed section.
2. Attach the drain hose to the air gap with the large drain hose 
clamp (provided).
NOTE: If the drain hose was cut, use 1
¹⁄₂" to 2" (3.8 to 5 cm) 
screw-type clamp (not provided).
3. Use a rubber hose connector (not provided) with screw-type 
clamps (not provided) to connect the air gap to the waste 
disposer inlet above the drain trap and at least 20" (50.8 cm) 
above the floor.
4. Insert the drain hose through the hole cut in the cabinet and to 
the front and center of the opening where the drain 
connection will be made.
Connect Drain Hose to Air Gap—No Waste Disposer
1. Cut the end of the drain hose, if needed.
NOTE: Do not cut the ribbed section.
2. Attach the drain hose to the air gap with the large drain hose 
clamp (provided).
NOTE: If the drain hose was cut, use 1
¹⁄₂" to 2" (3.8 to 5 cm) 
screw-type clamp (not provided).
A. Drain hose—cut here, if needed
B. Screw-type clamps
C. Air gap
D. Large drain hose clamp 
(provided)
E. Drain hose
F. Rubber hose connector 
(not provided)
G. Disposer inlet
H. Drain trap
A. Drain hose
A
B
C
D
E
F
G
H
A