Yamaha 006IPTO-F0 Manual Do Utilizador

Chapter 20—Other Functions

This page enables you to set various Automix preferences.

This page contains the following parameters. (These parameters are explained in the order 
from the top of the left column to the bottom of the right column).

If this check box is on, when Automix recording stops, a confirmation message appears  ask-
ing if you want to update the current Automix with the latest edits.

If this check box is on, EQ settings are automatically punched into the Automix recording 
when you adjust an EQ control in the SELECTED CHANNEL section.

If this check box is on, the fader value recorded immediately before the specified IN point 
is copied to the specified TO point when you copy or move the Fader events. This eliminates 
fader position matching problems when no fader event exists at the specified TO point.

If this check box is on, the Timecode Capture memory is incremented automatically each 
time a timecode address is captured on the Automix | Event Edit page (see page 211).

If this check box is on, the Capture memories on the Automix | Event Edit page are linked 
to the Locate memories.

If this check box is on, the previously-recorded channel events are automatically cleared 
when Automix recording (with Auto Rec on) stops.

If this check box is on, the indicated timecode is offset based on the OFFSET parameter on 
the Main page.

If this check box is on, MTC full-frame messages, in addition to the usual quarter-frame 
messages, are recognized and Automix follows them. If this check box is off, only the usual 
quarter-frame messages are recognized.

Automix data is compressed while recording. If this check box is on, the DM1000 displays 
the compressed size of the Automix.