Yamaha 006IPTO-F0 Manual Do Utilizador
272
Chapter 20—Other Functions
DM1000 Version 2—Owner’s Manual
Creating a Custom Layer by Combining Channels (User
Assignable Layer)
Assignable Layer)
If you set the Remote Layer target to “USER ASSIGNABLE,” you can create a custom layer
by combining any DM1000 channels (excluding the Stereo Out). This custom layer is called
“User Assignable layer.” You can use either Remote 1 or Remote 2 for a User Assignable layer.
by combining any DM1000 channels (excluding the Stereo Out). This custom layer is called
“User Assignable layer.” You can use either Remote 1 or Remote 2 for a User Assignable layer.
1 Press the DISPLAY ACCESS [REMOTE] button, then press the [F1] or [F2] but-
ton.
The Remote | Remote1 or Remote2 page appears.
2 Set the TARGET parameter to USER ASSIGNABLE, then press [ENTER].
A confirmation window appears.
3 Move the cursor to the YES button, then press [ENTER].
The DM1000 displays the page shown below.
4 Select the channels you wish to assign to the User Assignable layer using the
1–16 parameter boxes (
1
).
You can store up to four 16-channel setups in four banks by switching Banks 1–4 via the
BANK 1–4 buttons. If you press[ENTER] before selecting the channels to assign, you will
still be able to select the channels you wish to assign in the User CH Select window.
BANK 1–4 buttons. If you press[ENTER] before selecting the channels to assign, you will
still be able to select the channels you wish to assign in the User CH Select window.
5 Use the LAYER [REMOTE 1] or [REMOTE 2] button to assign or recall the User
Assignable layer.
You can use the faders, Encoders, and [ON] buttons to control the assigned channels.
Tip: You can reset the assignment to default by moving the cursor to the CLEAR button and
pressing [ENTER].
pressing [ENTER].
Tip: If you connected an optional MB1000 Meter Bridge, its meters indicate the level of the
channels currently-assigned to layer channels 1–16.
channels currently-assigned to layer channels 1–16.
1