Insys MoRoS ISDN 1.1.1 11-02-06-02-01.005 Manual Do Utilizador
Códigos do produto
11-02-06-02-01.005
Functions
MoRoS Modem/ISDN
34
June 06
As the writing of the update may take up to one minute, the values for the “Idle time”
should read "0", because no data is transmitted during the writing process. The system
update will be performed on the remote MoRoS despite a terminated connection. Any
possible messages regarding the success or failure will not be displayed.
should read "0", because no data is transmitted during the writing process. The system
update will be performed on the remote MoRoS despite a terminated connection. Any
possible messages regarding the success or failure will not be displayed.
If an error took place during the overwriting of the old system, the update procedure
may be repeated.
may be repeated.
In no case may the MoRoS perform a restart during an update procedure or
after a failed update! If the reset key is pressed or a voltage failure occurs,
the MoRoS will have no valid system and the device will not be able to start!
the MoRoS will have no valid system and the device will not be able to start!
A restart of the MoRoS will load the new system. Before a restart is performed, it may be
possible that the basic settings need to be restored first. This information can be taken
from the text file, which is supplied together with the update file.
possible that the basic settings need to be restored first. This information can be taken
from the text file, which is supplied together with the update file.
This field has information regarding the currently running system. These system data as
well as the set IP address should be available if you want to contact the INSYS support.
well as the set IP address should be available if you want to contact the INSYS support.
This field also displays the messages regarding the last ten connections. A successful
connection setup will be recorded with “CONNECT”. If a connection setup was
unsuccessful, the reason why the connection could not be established will be recorded.
connection setup will be recorded with “CONNECT”. If a connection setup was
unsuccessful, the reason why the connection could not be established will be recorded.