Dacor MOH Manual Do Utilizador

Installation Instructions

Connecting to a Three (3) Wire Electrical 

System - Where Local Codes Permit

Do not connect the green appliance conduit wire to the 

neutral (white) junction box wire unless local building 

codes permit.

1.  Separate the wires coming out of the appliance conduit.
2.  Connect the green and white wires from the appliance 

conduit to the white (neutral) supply wire in the junction 

box.

3.  Connect the black wire from the appliance conduit to 

the black (L1) supply wire in the junction box.

4.  Connect the red wire from the appliance conduit to the 

red (L2) supply wire in the junction box.

Junction box

Cable from circuit breaker 

panel or fuse box

Conduit to 

wall oven

RED

WHITE

BLACK

GREEN

RED

WHITE

BLACK

Wire nut

(3 places)

Connecting to a Three (3) Wire Electrical 

System with External Ground - Where Local 

Codes Permit

•  Do not connect the green appliance wire to the junc-

tion box or to a cold water pipe unless local building 

codes permit.

•  Do not ground the appliance to a gas supply pipe or 

hot water pipe.

•  If connecting the ground wire to a grounded cold water 

pipe, connect using a separate copper grounding 

wire (No. 10 minimum) and a clamp with an external 

grounding screw. The grounded cold water pipe must 

have metal continuity to electrical ground and must not 

be interrupted by insulating materials. Any insulating 

materials must be jumped, with a minimum, 4 AWG 

wire to establish continuity to ground.

If the junction box has been properly grounded by a 

licensed electrician, the green (ground) wire from the 

appliance conduit may be connected to the junction box 

using a loop terminal.

See the diagram on the following page. To connect the 

green appliance conduit wire to a grounded cold water 

pipe:
1. Separate the wires coming out of the appliance conduit.
2. Connect the white wire from the appliance conduit to the 

white (neutral) supply wire in the junction box.
3. Connect the black wire from the appliance conduit to the 

black (L1) supply wire in the junction box.
4. Connect the red wire from the appliance conduit to the 

red (L2) supply wire in the junction box.
5. Connect the green wire from the appliance conduit to a 

grounded cold water pipe as shown. Jumper any insulating 

materials as shown above with a length of No. 4 copper 

wire. Securely clamp the wire to bare metal at both ends.

Clamps

Bare metal

Meter

No. 4 copper 

wire

Metal water

pipe