Lowrance electronic LMF-200 Manual Do Utilizador
47
3. Highlight
P
ORT
E
NG
and press
MENU.
Select
C
HANGE
E
NGINE
and press
MENU,
which will open the Select
Engine menu with up to three options
(Port, Center and Starboard), depending on your engine-tank
configuration.
4.
Highlight
S
TARBOARD
and press
MENU.
5.
You will be taken back to the Bus Devices list, where the engine
interface you selected (formerly Port Eng) will now be displayed as
Stbd Eng. If the newly configured interface is not shown, refresh the
Bus Devices list.
Fuel Warning:
The Fuel Warning allows you to set a Low Level or High Level alarm
for each Suzuki Engine Interface on the network. A pop-up window will
appear if fuel rises above or falls below a threshold of your choosing.
1. Press
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
MENU
.
2. Highlight
B.
D
EVICES
and press
MENU
. After a few moments, the Bus
Devices list will appear.
3. Select an engine interface and press
3. Select an engine interface and press
MENU
.
4. Highlight
F
UEL
W
RNG
and press
MENU
. The Select Level menu will
appear with two options: Low Level and High Level.
5.
5.
Select
L
OW
L
EVEL
and press
MENU
, which will
open the Level
Percentage window. It will be set to Off by default. To set the Fuel
Warning to High Level Repeat steps 1-4, then select
H
IGH
L
EVEL
from the
Select Level menu.
6.
Use the
UP
and
DOWN
keys to set the desired fuel warning
percentage and press
MENU.
You will be taken back to the Bus Devices
list.
NOTE:
NOTE:
To see fuel remaining information from the Suzuki Engine
Interface, you must change the Fuel Remaining Source to
Eng/FFlow. See page 28.
Reset:
The Reset command in the engine interface menu allows you to reset
configuration and calibration settings for a particular interface.
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
MENU
.
2. Highlight
B.
D
EVICES
and press
MENU
. The Bus Devices list will
appear.