Kenwood TK-2102G Manual Do Utilizador

TK-2102G

User mode

PC mode

PC test mode

PC tuning mode

Data programming mode

User mode 

For normal use.

PC mode

Used for communication between the trans-
ceiver and PC.

Data programming 
mode

Used to read and write frequency data and 
other features to and from the transceiver.

PC test mode

Used to check the transceiver using the PC. 
This feature is included in the FPU.

User mode

Power ON

PC mode

Received commands from PC

The transceiver is programmed by using a personal com-

puter, a programming interface (KPG-22/22A), USB adapter 
(KCT-53U) and programming software (KPG-55D (ver.4.00 or 
later)).

The programming software can be used with a PC. Fig-

ure 1 shows the setup of a PC for programming.

1.  Connect the transceiver to the personal computer with 

the interface cable and USB adapter (when the interface 
cable is KPG-22A, the KCT-53U can be used.).

•  You must install the KCT-53U driver in the computer to 

use the USB adapter (KCT-53U).

•  When using the USB adapter (KCT-53U) for the fi rst time, 

plug the KCT-53U into a USB port on the computer with 
the computer power ON.

2.  When the POWER is switched on, user mode can be en-

tered immediately.  When the PC sends a command, the 
transceiver enters PC mode.

 

When data is transmitting from the transceiver, the red 
LED lights.

 

When data is received by the transceiver, the green LED 
lights.

•  The data stored in the personal computer must match 

the Model Name when it is written into the EEPROM.

•  Do not press the [PTT] key during data transmission or 

reception.

•  Change the transceiver to PC mode, then attach the in-

terface cable.

The KPG-22/22A is required to interface the transceiver 

with the computer.  It has a circuit in its D-sub connector 
(KPG-22: 25-pin, KPG-22A: 9-pin) case that converts the RS-
232C logic level to the TTL level.

The KPG-22/22A connects the SP/MIC connector of the 

transceiver to the RS-232C serial port of the computer.

The KCT-53U is a cable which connects the KPG-22A to 

a USB port on a computer.

When using the KCT-53U, install the supplied CD-ROM 

(with driver software) in the computer.  The KCT-53U driver 
runs under Windows 2000 or XP.

Press, then 
speak into the 
microphone to 
call a station.  
Release to 
receive.

Press and hold to 
turn the squelch 
OFF.  You will 
hear background 
noise.  Release 
to turn the 
squelch back ON.

Lights red while 
transmitting.  
Lights green while 
receiving a signal.  
Flashes red when 
the battery voltage 
is low while 
transmitting.

Turn clockwise 
to switch ON the 
transceiver.  To 
switch OFF the 
transceiver, turn 
counterclockwise 
until a click 
sounds.  Rotate 
to adjust the 
volume level.

Rotate to select 
channels 1  ~  16.

(KNB-15A)