Kenwood TK-2102G Manual Do Utilizador

TK-2102G

■ Removing the case assembly from the chassis

1.  Remove the two knobs 

q, cushion w  and three round 

nuts 

e.

2.  Remove the two screws 

r.

3.  Expand the right and left sides of the bottom of the case 

assembly, then Iift and remove the chassis from the case 
assembly 

t.

:

@

.

.

.

:

;

;

=

4.  Taking care not to cut the speaker lead 

y, open the 

chassis and case assembly.

B

■ Removing the TX-RX unit from the chassis

1.  Remove the eleven screws 

u.

2.  Remove the VOL/CH FPC from the TX-RX unit connector 

(CN400) 

i.

3.  Remove the solder from the antenna terminal using a 

soldering iron, then lift the unit off 

o.

4.  Remove the waterproof packing 

!0 and cushion !1 from 

the antenna connector.

 

Note: The cushion cannot be reused. Affi x a new cush-
ion when you remove the cushion.

5. Remove the two screws 

!2 and remove the antenna con-

nector.

 

Note: When reassembling the unit in the chassis, be 
sure to solder the antenna terminal.

CN400

Antenna
terminal

>

>

> >

>

>

>

2

8

>

>

■ Removing the lever

1.  Press down the lever on the lower case 

!3, insert a small 

fl at-head screwdriver into the space between the case 
and lever, open the case carefully 

!4 and lift the lever off.

 

Note: Do not force to remove the lever from the case.

Case assembly

Lever knob