Kenwood TK-5910 Manual Do Utilizador

Press the 

 switch to switch the transceiver ON.

•  A beep sounds and the display momentarily lights up.
•  If the Transceiver Password function is programmed, “PASSWORD” appears on the 

display.  You must enter the password to unlock the transceiver.  Refer to “Transceiver 

Password”, below.

Press and hold the 

 switch for approximately  second to switch the transceiver 

OFF.

■

  To enter the password:

1  Rotate the CH control to select a digit.
2  Press the GRP 

 key to accept the entered digit and move to the next 

digit.

3  Repeat steps  and  to enter the entire password.

•  The password can contain a maximum of 6 digits.
•  Press the 

PF 3 key to delete an incorrectly entered character.  Press and hold 

the 

PF 3 key to delete all characters.

4  Press the PF 2 key to confirm the password.

•  If you enter an incorrect password, an error tone sounds and the transceiver 

remains locked.

  To enter the password using a DTMF keypad:

1  Press the DTMF keys corresponding to the password digits.

•  The password can contain a maximum of 6 digits.
•  Press the 

PF 3 or DTMF # key to delete an incorrectly entered character.  Press 

and hold the 

PF 3 or DTMF # key to delete all characters.

2  Press the PF 2 or DTMF

key to confirm the password.

•  If you enter an incorrect password, an error tone sounds and the transceiver 

remains locked.

Rotate the 

VOL control clockwise to increase the volume and counterclockwise to 

decrease the volume.