Kenwood TK-5910 Manual Do Utilizador

4

■

1  Press the key programmed as Autodial.

•  The last called unit appears on the display.
•  Press the 

PF 2 key to switch the display between the unit name and the list 

number.

2  Press and hold the PF 2 key to enter Store & Send mode.
3  Enter the desired digits using the DTMF keypad.

•  Alternatively, you can select a digit by rotating the 

CH control, and then set the 

selected digits by pressing the 

 key.  Repeat this process to enter the 

entire number.

4  Press the PTT switch to make the call.

•  Alternatively, you can press the 

PF 4 key to page the selected unit, rather than 

making a call.

■

1  Press the key programmed as Autodial.

•  The last called unit appears on the display.
•  Press the 

PF 2 key to switch the display between the unit name and the list 

number.

2  Rotate the CH control to select your desired list number.
3  Press the PTT switch to make the call.

•  Alternatively, you can press the 

PF 4 key to page the selected unit, rather than 

making a call.

1  When a call is received, a ringing tone will sound and “PHONE CALL” will 

appear on the display.

2  Press and hold the PTT switch to speak, and release it to receive.

•  Only one person can speak at a time.

1  Select your desired zone and channel.
2  Press the key programmed as Status to enter status mode.
3  Rotate the CH control to select the status ID you want to transmit.
4  Press the PTT switch or the PF 4 key to initiate the Status call.

•  After the status call has been successfully received by the called unit, “COMPLETE” 

appears on the display.