Kenwood K2E Manual Do Utilizador

TH-K2AT/K2E/K2ET

35

1.Setting and

Connect the optional PG-2W

LCD total illumination display

Initial configuration displayed after

resetting

DC cable to the power supply.

the full-reset.

DC IN terminal voltage: 13.8V

1) Total illumination display

confirmation

Turn the Transceiver Power ON by pressing the power switch while the [F] key is pressed.

While the [F] key is pressed, all LCD segments light.

2) Full-resetting

After confirming that all LCD segments have lighted described in the Step 1 above, release

the [F] key, and then press the [F] key twice while “FL.RST?” appears on the display.

2 VCO

After removing 3 screws fixing

Lock voltage the TX-RX unit (B/3), remove

Check

the TX-RX (B/3) unit from the

CN9 connector of the TX-RX

unit (A/3).

1) Frequency: 136.000MHz

DVM

TX-RX

LV

Check

0.7V or more

                RX

2) Frequency: 173.990MHz

(A/3)

4.3V or less

                TX

TX power: Low

1) Frequency: 136.000MHz

0.7V or more

PTT: ON

2) Frequency: 173.990MHz

4.3V or less

PTT: ON

After observing the VCO

lock voltage, connect the

TX-RX unit (B/3) to the

original position.

3.TX frequency 1) TX power: Low

f. counter

ANT

TX-RX

VR1

145.990MHz

±150Hz

Adjust

Frequency: 145.990MHz

(A/3)

PTT: ON

4.Overvoltage

Switch to Adjustment mode

warning

and carry out the operations

reference

for adjustment item A.

voltage

(Refer to page 28)

Adjust/Check 1) LCD display: DC

DC power supply

[MENU]

Write

Frequency: 145.050MHz

(E, E3)

Frequency: 146.050MHz

(K, K2, M, M2)

DC IN terminal voltage: 14.8V

To exit from the Adjustment

Mode, turn the transceiver

power OFF and then ON.

2) Frequency: 145.050MHz

Check

Alarm sound and

(E, E3)

display “DC ERR”

Frequency: 146.050MHz

message.

(K, K2, M, M2)

DC IN terminal voltage: 17.5V