Lowrance electronic HDS 10 Manual Do Utilizador

Most installation problems are caused by shortcuts taken with system cables. When wiring the 

HDS follow the guidelines below.

Don’t make sharp bends in the cables

Do make drip and service loops

Don’t run cables in a way that allows water 

to flow down into the connectors

Do tie-wrap all cables to keep them secure

Don’t route the data cables in areas adjacent 

to radar, transmitter, or large current 

carrying cables

Do leave room at the back to install and 

remove cables

Before starting the installation, be sure to turn electrical power off. If power is 

left on or turned on during the installation, fire, electrical shock, or other serious 

injury may occur. Be sure that the voltage of the power supply is compatible 

with the HDS display.

The HDS has a voltage rating of 10-19V DC. 

The red wire should always be connected to (+) DC V using a fuse or thermal 

breaker (10 Amp)