Mitsubishi Electronics Q170MCPU Manual Do Utilizador
8 - 1
8
8 EMC DIRECTIVES
8. EMC DIRECTIVES
Compliance to the EMC Directive, which is one of the EU Directives, has been a legal
obligation for the products sold in European countries since 1996 as well as the Low
Voltage Directive since 1997.
Manufacturers who recognize their products are compliant to the EMC and Low
Voltage Directives are required to declare that print a "CE mark" on their products.
obligation for the products sold in European countries since 1996 as well as the Low
Voltage Directive since 1997.
Manufacturers who recognize their products are compliant to the EMC and Low
Voltage Directives are required to declare that print a "CE mark" on their products.
MODEL
MITSUBISHI ELECTRIC
MITSUBISHI
US LISTED
UL
80M1
IND. CONT. EQ
C
MOTION CONTROLLER
PASSED
Q170MCPU
SERIAL
JAPAN
B8Y054306
CE mark
(1) Authorized representative in Europe
Authorized representative in Europe is shown below.
Name : Mitsubishi Electric Europe BV
Address : Gothaer strase 8, 40880 Ratingen, Germany
Name : Mitsubishi Electric Europe BV
Address : Gothaer strase 8, 40880 Ratingen, Germany
8.1 Requirements for Compliance with the EMC Directive
The EMC Directive specifies that products placed on the market must be so
constructed that they do not cause excessive electromagnetic interference
(emissions) and are not unduly affected by electromagnetic interference (immunity)".
Section 8.1.1 through Section 8.1.4 summarize the precautions on compliance with
the EMC Directive of the machinery constructed with the Motion controllers.
These precautions are based on the requirements and the standards of the regulation,
however, it does not guarantee that the entire machinery constructed according to the
descriptions will comply with above-mentioned directive. The method and judgement
for complying with the EMC Directive must be determined by the person who
construct the entire machinery.
constructed that they do not cause excessive electromagnetic interference
(emissions) and are not unduly affected by electromagnetic interference (immunity)".
Section 8.1.1 through Section 8.1.4 summarize the precautions on compliance with
the EMC Directive of the machinery constructed with the Motion controllers.
These precautions are based on the requirements and the standards of the regulation,
however, it does not guarantee that the entire machinery constructed according to the
descriptions will comply with above-mentioned directive. The method and judgement
for complying with the EMC Directive must be determined by the person who
construct the entire machinery.