Agilent Technologies 6683A Manual Do Utilizador

2010

IF Err THEN

2020

    PRINT "An error occurred during the EEPROM read/write, Check for"

2030

    PRINT "programming errors. Initialization data may be incorrect."

2040

    STOP

2050

END IF

2060

!

2070

PRINT "Operation complete. Program stopped."

2080

STOP

2090

!

2100  Ps_error:

! Error handling subroutine

2110

OUTPUT @Ps;"SYST:ERR?"

! Check for errors

2120

ENTER @Ps;Err

2130

RETURN

2140

!

2150

END

   Shock Hazard: To avoid the possibility of personal injury, remove the power supply from service before
   removing the top cover. Turn off the ac power and disconnect the line cord, GPIB cable, load leads, and

remote sense leads before attempting any disassembly. Any disassembly work must only be performed by
a qualified support technician.

Observe that the DC RAIL assembly LEDs (DS420 & DS421) are fully extinguished (no live voltages
present) before attempting any disassembly work. Any disassembly work must only be performed by a
qualified support technician.

Cable connections are shown in Figure 6-2 of Chapter 6 and component part numbers are given in Chapter 5. Reassembly
procedures are essentially the reverse of the corresponding disassembly procedures.

þ

  TORX screwdriver size T-15 (for most all retaining screws).

 
þ

  TORX screwdriver size T-20 (for power supply carry straps).

 
þ

  Seven (7) mm metric hex driver (to remove GPIB read connector).

 
þ

  Pencil, paper, and labels to make notes to aid in the reinstallation of components.

 
þ

  Work at a static-free station such as a table covered with static-dissipative laminate or with a conductive table mat

(Agilent P/N 9300-0797, or equivalent) using a conductive wrist strap where necessary, such as, Agilent P/N
9300-0969 or 9300-0970.