Renesas R5S72623 Manual Do Utilizador
Section 15 Serial Communication Interface with FIFO
Page 762 of 2108
R01UH0134EJ0400 Rev. 4.00
Sep
24,
2014
SH7262 Group, SH7264 Group
(1) Transmit/Receive Formats
The data length is fixed at eight bits. No parity bit can be added.
(2) Clock
An internal clock generated by the on-chip baud rate generator by the setting of the C/A bit in
SCSMR and CKE[1:0] in SCSCR, or an external clock input from the SCK pin can be selected as
the transmit/receive clock.
SCSMR and CKE[1:0] in SCSCR, or an external clock input from the SCK pin can be selected as
the transmit/receive clock.
When this module operates on an internal clock, it outputs the clock signal at the SCK pin. Eight
clock pulses are output per transmitted or received character. When transmission or reception is
not performed, the clock signal remains in the high state. When only receiving, the clock signal
outputs while the RE bit of SCSCR is 1 and the number of data in receive FIFO is more than the
receive FIFO data trigger number.
clock pulses are output per transmitted or received character. When transmission or reception is
not performed, the clock signal remains in the high state. When only receiving, the clock signal
outputs while the RE bit of SCSCR is 1 and the number of data in receive FIFO is more than the
receive FIFO data trigger number.
(3) Transmitting and Receiving Data
Initialization (Clock Synchronous Mode)
Before transmitting, receiving, or changing the mode or communication format, the software
must clear the TE and RE bits to 0 in the serial control register (SCSCR), then initialize this
module. Clearing TE to 0 initializes the transmit shift register (SCTSR). Clearing RE to 0,
however, does not initialize the RDF, PER, FER, and ORER flags and receive data register
(SCRDR), which retain their previous contents.
must clear the TE and RE bits to 0 in the serial control register (SCSCR), then initialize this
module. Clearing TE to 0 initializes the transmit shift register (SCTSR). Clearing RE to 0,
however, does not initialize the RDF, PER, FER, and ORER flags and receive data register
(SCRDR), which retain their previous contents.