Honeywell VR8204 Manual Do Utilizador

VR8104, VR8204 AND VR8304 INTERMITTENT PILOT COMBINATION GAS CONTROLS

69-1225—4

Fig. 5. Proper use of wrench on gas control with and without flanges.

Fig. 6. Top view of gas control.

Fig. 7. Always use new compression fitting.

Wiring

Follow the wiring instructions furnished by the appliance
manufacturer, if available, or use the general instructions
provided below. When these instructions differ from the
appliance manufacturer, follow the appliance
manufacturer instructions.

All wiring must comply with applicable electrical codes
and ordinances.

Disconnect power supply before making wiring
connections to prevent electrical shock or equipment
damage.

Check the power supply rating on the gas control
and make sure it matches the available supply.
Install a transformer, thermostat and other controls
as required.

Connect control circuit to the gas control terminals.
See Fig. 8.

APPLY WRENCH
FROM TOP OR
BOTTOM OF GAS
CONTROL TO
EITHER SHADED AREA

WHEN FLANGE IS NOT USED

APPLY WRENCH
TO FLANGE ONLY

WHEN FLANGE IS USED

M3079

HI-LO
ADJUSTMENT SCREWS
(UNDER CAP)

REGULATOR
VENT COVER

INLET

OUTLET

M10968A

OUTLET
PRESSURE
TAP

WIRING
TERMINALS (3)

INLET
PRESSURE TAP

PRESSURE REGULATOR
ADJUSTMENT
(UNDER CAP SCREW)

PILOT OUTLET

PILOT ADJUSTMENT
(UNDER CAP SCREW)

GAS
CONTROL
KNOB

TWO-STAGE
PRESSURE
REGULATOR
MODEL

GAS CONTROL

TIGHTEN NUT ONE TURN
BEYOND FINGER TIGHT.

FITTING BREAKS OFF AND CLINCHES
TUBING AS NUT IS TIGHTENED.

TO PILOT
BURNER

M3076A