Philips PPX4835/EU Manual Do Utilizador
Initial operation
8
3 Initial operation
Setting up the device
Place the projector on a flat surface in front of
the projection surface. In case you need to tilt
the device slightly upwards (e.g.: when using a
tripod) you can correct the distortion by using
the built-in keystone correction.
the projection surface. In case you need to tilt
the device slightly upwards (e.g.: when using a
tripod) you can correct the distortion by using
the built-in keystone correction.
Connect power supply /
charge battery
charge battery
Power is supplied through the power supply
(included), one end is connected to the power
jack on the rear side of the device, the other
(included), one end is connected to the power
jack on the rear side of the device, the other
end to the AC100
~
240V wall outlet.
Navigation for settings menu
Navigation can be done by navigation keys
(
¡/¢/À/Á/à and
).
Navigation keys:
¡/¢ – Scroll trough the settings menu.
à – Go one level down.
In the final level,
à accepts a setting and
automatically returns to the last submenu.
– Go one level up.
The
key aborts a setting and
automatically returns to the last submenu
(or exits the menu depending on the menu-
level).
Initial installation
1 Push the POWER
button for 3 seconds till
the power indicator turns to green to turn
the device on.
the device on.
2 Turn the device towards a suitable projection
surface or wall. Note that the distance to the
projection surface must be a minimum of
0.5 meters and a maximum of 5 meters. Make
sure the projector is in a secure position.
projection surface must be a minimum of
0.5 meters and a maximum of 5 meters. Make
sure the projector is in a secure position.
3 Use the focus wheel on the right side to adjust
the image sharpness.
4 The first time you turn on the device, you
should finish the main settings.
Setup language
In order to change the menu language, proceed
as follows:
as follows:
1 When the device is turned on, press the
à
button to enter the menu Settings.
Settings 1/1
Image Settings
Sound Settings
Brightness mode
Language
Flashlight
SOS Light
Warning Light
Maintenance
Image Settings
Sound Settings
Brightness mode
Language
Flashlight
SOS Light
Warning Light
Maintenance
2 Select Language with
¡/¢ buttons.
3 Confirm with
à.
4 Select your desired language with
¡/¢ but-
tons.
5 Confirm with
à.
6 Press
to return to the menu one level up.