Philips DVP6620/93 Manual Do Utilizador

43

–  Press STANDBY-ON on the unit to turn on the 

power.

–  Ensure that the AC outlet have power.
–  Disconnect the power cord from the power outlet 

for a few minutes. Reconnect the power cord and try 
to operate again as usual.

–  Refer to your TVs manual for correct Video In 

channel  selection. Change the TV channel until you 
see the DVD screen.

–  If this happens when you turn on the progressive scan 

feature or change the HDMI video setting, wait for 15 
seconds for the auto recovery or switch back to the 
default mode as below:

1) Press OPEN/CLOSE ç on this unit.
2) Press numeric keypad ‘1’ on the remote control. 

–  Check the video connection.
–  Sometimes a small amount of picture distortion may  

 appear. This is not a malfunction.

–  The disc is dirty. Clean the disc.

–  Check the audio connections to the connected audio 

device.  

–  Make sure that the connected audio device is turned 

on to the correct input source.

–  Set the digital output setting correctly, based on the 

device you connected to this unit.

–  Aim the remote control directly at the sensor on the 

front of this unit (not towards the TV).

–  Remove any obstacles between this unit and the 

remote control.

–  Batteries are weak, replace the batteries.
–  Check the polarities of the batteries are as indicated 

on the remote control (± signs).

WARNING
Under no circumstances should you try to repair this unit yourself, as this invalidate the 
warranty. Do not open this unit as there is a risk of electric shock.

If a fault occurs, fi rst check the points listed below before taking this unit for repair. If you 
are unable to remedy a problem by following these hints, consult your dealer or Philips for 
help.

1_dvp6620-88_93_eng1_final813.in43   43

1_dvp6620-88_93_eng1_final813.in43   43

2008-03-24   2:32:35 PM

2008-03-24   2:32:35 PM