Sanyo PLC-WM5500L Guia Do Utilizador

Página de 92
70
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering, give the following information to the 
dealer.
 
   
Model No . of your projector 
PLC-WM5500, PLC-WM5500L
 
 
 
Replacement Lamp Type No . 
POA-LMP16  
 
 
   
   
 
    (Service Parts No. 610 346 9607)
Maintenance and Care
This projector uses a high-pressure lamp which must be handled carefully and properly. 
Improper handling may result in accidents, injury, or create a fire hazard.
 Lamp  lifetime  may  differ  from  lamp  to  lamp  and  according  to  the  environment  of  use.  There  is  no 
guarantee  of  the  same  lifetime  for  each  lamp.  Some  lamps  may  fail  or  terminate  their  lifetime  in  a 
shorter period of time than other similar lamps.
 If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights up, 
replace the lamp with a new one IMMEDIATELY after the projector has cooled down. (Follow carefully 
the instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the 
LAMP REPLACE indicator lighted may increase the risk of lamp explosion.  
 Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime 
draws to an end. Risk of explosion may differ according to the environment or conditions in which the 
projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETy PRECAUTIONS SHOULD BE TAKEN .
If  a  lamp  explodes,  disconnect  the  projector’s  AC  plug  from  the  AC  outlet  immediately.  Contact  an 
authorized  service  center  for  a  checkup  of  the  unit  and  replacement  of  the  lamp.  Additionally,  check 
carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out 
from  the  cooling  air  circulation  holes. Any  broken  shards  found  should  be  cleaned  up  carefully.  No  one 
should  check  the  inside  of  the  projector  except  those  who  are  authorized  trained  technicians  and  who 
are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those 
who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken 
glass.
          LAMP HANDLING PRECAUTIONS